Electrical Installation Instructions
ARCTIC SPAS® MUST BE WIRED IN ACCORDANCE WITH ALL APPLICABLE LOCAL ELECTRICAL CODES. ALL ELECTRICAL WORK SHOULD BE DONE BY AN EXPERIENCED, LICENSED ELECTRICIAN AND APPROVED BY A LOCAL BUILDING/ELECTRICAL INSPECTION AUTHORITY.
The electrical supply must satisfy the requirements of the spa as marked on the certification label which is located adjacent to the spa controller (pack). If the ratings are not legible or cannot be found, please contact the factory for assistance. – DO NOT GUESS!
WARNING: Removing or bypassing any GFCI /RCD breaker will result in an unsafe spa and will void the spa’s warranty.
IMPORTANT: Your Arctic Spa has been carefully engineered to provide maximum safety against electric shock. Remember, connecting the spa to an improperly wired circuit will negate many of its safety features.
Note to European customers:
8’ Epic Series Electrical Requirements are 240 Volt, 40 AMP Single Phase or 2-20 AMP or 3-20 AMP or 3-16 AMP you have the choice of a 1, 2, or 3 phase power supply at 16, 20, 25, 32, 40, 50, & 60 amperages.
DANGER! Shock Hazard.
DO NOT PROCEED if you are not a licensed electrician. This diagram is for reference only!